Search results for 'John Deere'
-
John Deere solder-on tank set
This set matches brass kit #9700.
Learn More
-
Case solder-on tank set
Top Tank
This tank has a 1 1/2" diameter hose connection 1 3/4" from the edge of the tank to the center of the hose connection, and a 7/8" hole on the top for an import filler neck (part#1005).
Bottom Tank
This tank has a 1 1/2" diameter hose connection in the center of the tank, and a 1/4" NPT flange for a drain fitting on the grill side of the tank.
Learn More
-
John Deere tank set
Top Tank
This tank has a 2" diameter hose connection, and 1 1/4" diameter hole for a filler neck.
Bottom Tank
This tank has a 2" diameter hose connection, and a 1/4" NPT flange for a drain.
Learn More
-
John Deere solder-on tank set
The top tank has a 1 1/2" diameter hose connection and a hole for a filler neck, and the bottom tank has a 1 7/8" diameter hose connection, and a 1/4" NPT flange for a drain fitting on the grill side.
Learn More
-
Case Loader solder-on tank
This tank has a 2 1/4" diameter hose connection 7 1/4" in from the edge of the tank to the center of the hose connection.
Learn More
-
John Deere solder-on tank set
These tanks have 2" diameter hose connections. The top tank has a hole for a filler neck, and the bottom tank has three 1/2" NC threaded mounting studs and a 1/4" NPT flange for a drain fitting.
Learn More
-
Case Loader solder-on set
These tanks have a 2 1/2" diameter hose connection. The top tank has a hole for a filler neck and a deflection baffle under the fill hole. The bottom tank has a 1216PC oil cooler and a 1/4" NPT flange for a drain fitting.
Learn More
-
John Deere bottom tank
This tank has a bolt-on type flange, two 5/8" NC mounting studs @ 16 1/4" centers, a PTO through hole, and a 1/4" NPT flange for a drain fitting.
SAMPLE REQUIRED Learn More
-
Generator solder-on tank set
These tanks have a 2 1/4" diameter hose connection 5 1/2" from the edge of the tank to the center of the hose connection, and a mounting bracket on each end with two 5/16" NC threaded holes (to attach side frames).
The top tank has a 1 1/4" hole for a filler neck, and a 3/8" NPT flange near the hose connection. The bottom tank has a pair of 1/4" NPT flanges for drain fittings.
John Deere Generator application. Learn More
-
John Deere mounting bracketThis bracket is designed tofit over the bottom tank of brass kit #9700 (tank #3047), or the bottomtank of the corresponding steel kit #080808A.
There are six 3/8"NC threaded mounting holes, eight 3/8" clearance holes, a cut-out forthe hose connection, and a cut-out to access the drain cock.
Learn More