Bottom Tank
-
Solder-on bottom tank
This tank has a 1 1/2" diameter hose connection 2 1/2" long, and a 1/2" NPT flange for a drain fitting.
Learn More -
Lift Truck solder-on bottom tank
This tank has a 1 3/8" diameter hose connection 1 3/4" from the edge of the tank to the center of the hose connection, and an oil cooler measuring 11 1/2" from center to center (original oil cooler measured 15" center to center).
Note: this tank was made deeper to accommodate the different style oil cooler.
Learn More -
Ford solder-on tank
This tank has a 2" diameter hose connection, a 1/4" NPT flange for a drain fitting, and two mounting bosses to attach side frames. The tank is made deep enough to accommodate an oil cooler.
Learn More -
Komatsu Loader bottom tank
This tank has a 2 1/4" diameter hose connection 2" from the edge of the tank to the center of the hose connection, a 3/8" diameter bypass connection 7" from the edge of the tank, and a 14 plate oil cooler 18 7/8" center to center ( if not supplied by the customer, a 18" center to center oil cooler can be used in it's place).
Note: original cooler has a Komatsu thread, the cooler that can be provided is equipped with 3/4" NPT thread, or we can RE/RE your old cooler into the new tank.
Call for pricing and details.
Learn More -
Gen Set solder on bottom tank
This tank has a bolt-on flange connection, and two 1/2" NC mounting studs @ 17 7/8" centers.
Note: the studs were added to the original design to bolt through the bottom channel.
Learn More -
Case solder-on bottom tank - 1994
This tank has a 2 1/4" diameter hose connection 4 1/8" in from the edge of the tank to the center of the hose connection, a 1/4" NPT flange for a drain, and a bracket on each end to mount side frames.
Learn More -
Fire Truck bottom tank
This tank has a 2 1/4" diameter hose connection that angles upward @ 90o, a 1 3/4" diameter tube running through the tank to accommodate a PTO, two 1/2" NPT threaded holes for a water pump cooler/heater, and a 3/8" NPT flange for a drain. Learn More -
Case Loader solder-on bottom tank
This tank has a 3" diameter hose connection, a 1 1/4" diameter hose connection that bends towards the ground at approx. 80o, a 1/4" NPT flange for a drain fitting, a 14 plate oil cooler with 18" centers (#1418PC), and a deflection baffle that partially covers the oil cooler.
Learn More -
Detroit Diesel solder-on bottom tank
This tank has two 5/16" NC threaded mounting studs @ 16" centers, and a 1/4" NPT flange for a drain fitting.
Learn More -
Case solder-on bottom tank
This tank has a 2 1/2" diameter hose connection 2 1/2" from the edge of the tank to the center of the hose connection, and a mounting bracket at each end.
Note: this tank matches with top tank #062207A.
Learn More