Solder on Tanks
-
Gen solder-on set
These tanks have 2 1/2" diameter hose connections and a 1/4" NPT flange. The top tank has tapered sides, and a 1 3/8" hole for a filler neck. Learn More -
Case solder-on tank set
These tanks have 2" diameter hose connections, and a mounting block on each end with two 5/16" NC threaded holes. The top tank has a 1 1/4" diameter hole for a filler neck, and the bottom tank has a 1/4" NPT flange for a drain fitting.
Learn More -
Cat solder-on tank
This tank has a 2" diameter hose connection, a 3/8" NPT flange for a drain, and a 1216PC plate oil cooler that replaces the 10 plate 15 1/2" center oil cooler.
Learn More -
Case solder-on tank
This tank has a 2 1/4" diameter hose connection, a 1/4" NPT flange, and two 1/2" NC threaded mounting studs @ 14 3/4" centers.
Learn More -
Case solder-on set
These tanks have 1 3/4" diameter hose connections and a mounting bracket. The outlet tank has a 7/8" stand pipe for a filler neck.
Learn More -
Volvo solder-on tank set
These tanks have a 1/4" NPT flange at each end, and the bottom has a 1" diameter hose connection, a 1 1/4" diameter hose connection, with a baffle separating them.
Learn More -
Solder-on tank set
Top Tank
This tank has a "British Thread" coupling in the center (to be supplied by customer), a 1/4" NPT flange for an expansion fitting, 39 1/8" long heavy steel bracket along the top with four 8mm x 1.25 nuts @36 1/4" centers end-to-end and @4 1/4" centers side-to-side.
Bottom Tank
This tank has a 2 3/8" diameter hose connection 6 1/2" from the edge of the tank to the center of the pipe, a 1/4" NPT flange for a drain fitting, and a reinforcing channel along the bottom 39 1/8" long x 5 1/4" wide.
Learn More -
Solder-on side frames
These frames have three 1/4" NC threaded mounting holes along each edge of the frame, and the bottom frame has two 1/2" NC threaded mounting holes along the back.
Top and bottom frames are identical except for the 1/2" mounting nuts on the bottom frame.
Learn More -
Solder-on tank set
Outlet Tank
This tank has a 1 1/8" diameter hose connection, and a stand pipe for a filler neck.
Inlet tank
This tank has a 1 1/8" diameter hose connection, and a 1/4" NPT flange for a drain fitting.
Learn More -
Komatsu solder-on tank set
Top Tank
This tank has a 2 3/8" diameter hose connection, a 3/4" diameter heater bypass connection, a 1/4" NPT flange, a hole in the top center for a filler neck, and a notch on each end. The inside of the tank contains a deflection baffle.
Bottom Tank
This tank has a 2" diameter hose connection, a 1 1/4" diameter NPT coupling, a 1/4" NPT flange for a drain, oil cooler holes 18" centers, call to request oil cooler plate size desired ...
Header size is the same as tank #101107A. Learn More