Miscellaneous
-
This filler neck installs into a 1 1/4" diameter hole. It has a depth of 3/4", and it has an inside diameter of 1 5/8".
Learn More -
This filler neck installs into a 1 1/4" diameter hole. It has a depth of 3/4", and it has an inside diameter of 1 5/8".
Learn More -
New Flyer Bus oil cooler core assembly
This cooler assembly has a bank of four 16 plate coolers with 10" centers. The unit is a cooler insert for tank #010808A.
Important Information!
The transmission plate oil coolers that Taalman supply are intended for use in systems that operate at 80 PSI to 125 PSI typical operating pressure.
The coolers are leak tested to 300 PSI and are statically burst tested to 1000 PSI.
Please ensure that the intended use of the cooler meets the above requirements. Taalman will NOT be responsible for any damage caused by failure of a cooler that is exposed to anything outside of the above parameters.
Learn More -
Paver utility tank
This tank has two sending units, a 5 1/2" wide channel through the middle, and a filler neck.
Learn More -
Cummins plate oil cooler
Important Information!
The transmission plate oil coolers that Taalman supply are intended for use in systems that operate at 80 PSI to 125 PSI typical operating pressure.
The coolers are leak tested to 300 PSI and are statically burst tested to 1000 PSI.
Please ensure that the intended use of the cooler meets the above requirements. Taalman will NOT be responsible for any damage caused by failure of a cooler that is exposed to anything outside of the above parameters.
Learn More -
Generic Hydraulic Reservoir Tank
This tank has five 2" NPT couplings, and six 1/2" NPT couplings. Learn More -
Utility Tank
Overall dimensions: 24 1/2" x 18" x 11"
One 3/4" NPT flange, one 1/8" NPT flange, and a filler neck. Learn More -
Utility Tank
This tank has a 2" NPT threaded nipple for the filler, a 5 bolt flange for the sending unit, a block with a 1/8" NPT threaded hole and a 1/4" NPT threaded hole, and a 1/2" NPT drain fitting on the bottom. Learn More -
Utility Tank
This tank has a 2" NPT nipple on the side of a filler neck, a 1/4" NPT fitting surrounded by a protection bracket for a sensor, a 5 bolt flange for a sending unit, two 1/2" NPT fittings, and two 3/8" NPT fittings for drains on the opposite side of the tank to the other fittings. Learn More -
Utility Tank
This tank has four mounting ears on the bottom, a 1/2" NPT flange on the top, a 3/4" NPT flange on the bottom, and a filler neck on the top.
Learn More