Search results for 'John Deere'
-
Cat / Case / John Deere solder on tank set
(both tanks are identical)
This tank has a 2 1/2" diameter hose connection 4" from the edge of the tank to the center of the pipe, a 3/8" NPT coupling for a drain or expansion fitting, and two mounting bolt sleeves for 3/8" diameter bolts @16 5/8" centers.
Learn More -
New Holland solder-on kit
These tanks have 1 3/4" diameter hose connections. The top tank has four rubber mounting bosses, and a filler neck. The bottom tank has a steel mounting bracket.
Learn More -
Case Tractor solder-on Btm tank
This tank has a 2 1/4" diameter hose connection, a 1/4" NPT flange for a drain fitting, and two 1/2" NC threaded studs @ 14 3/4" centers offset towards the engine.
Learn More -
John Deere/Case solder-on tank set
Top and bottom tanks are identical except for the 1 3/8" diameter fill neck hole on the top tank. There are four pin mounts on each tank for mounting the side frames, and a 2" diameter hose connection 4" from the edge of the tank to the center of the hose connection.
Note: kit comes with eight 5/16" x 6" NC bolts and nuts, and a #1001 GM filler neck.
Learn More -
Case Loader
Both tanks in this set are identical. Each has a 1 3/4" diameter hose connection 3 5/8" from the edge of the tank to the center of the hose connection, and four 5/16" NC threaded nuts for mounting the side panels.
Learn More -
Gasket Tape
This is cork gasket material made by Johnson Manufacturing. 50' roll @ 1/8" thick. Peel and stick on one side.
Learn More -
Gasket Tape
This is cork gasket material made by Johnson Manufacturing. 100' roll @ 1/16" thick. Peel and stick on one side.
Learn More -
John Deere solder-on tank set
These tanks have 2" diameter hose connections. The top tank has a 1 1/4" diameter hole for a filler neck, and the bottom tank has a 1/4" NPT flange for a drain fitting. Learn More -
Case Loader Bottom Tank
This tank has a 2 1/4" diameter hose connection, a 1/4"NPT fitting for a drain cock, a 3/4" diameter bypass hose, and a 14 plate oil cooler with 18" centers and 3/4" NPT fittings (replaces the original 15 plate with metric fittings).
Learn More -
Case solder-on side frame
This frame has four slotted holes along each edge, and two slotted holes on the back.
Note: sample rail needed or specs
Learn More