Search results for '609'
-
Kenworth Bolt on Complete Core 40" x 28.62" x 2 1/4", 4 row, VT style, top tank hose connection 2 1/2" dia., Taalman #5994 top tank, #609 Btm tank, #619R&L rails, #6105 Bracket Parts can be sold separately Learn More -
New Holland L180 Skid Steer solder-on set
These tanks have 1 3/4" diameter hose connections, two 3/8" NC threaded nuts, and two "ears" on the end of the tank to mount an oil cooler. The top tank has a hole for a filler neck and a lifting lug, and the bottom tank has a 1/4" NPT flange for a drain fitting. Learn More -
Motor Home bolt-on tank set
Top Tank
This tank has a 1 3/4" diameter hose connection, a hole in the top center for a filler neck, and two angle brackets on each end to attach side plates.
Bottom Tank
This tank has a 2 1/4" diameter hose connection, a 3/8" NPT flange for a drain, a 14 plate oil cooler with the fittings spaced @ 18" (1418PC), and two angle brackets at each end to attach side plates.
Note: samples are required to build this set.
Learn More -
Cat Loader solder-on tank
This tank has a 2 1/2" diameter hose connection 8" from the edge of the tank to the center of the hose connection.
Learn More -
New Flyer Bus oil cooler core assembly
This cooler assembly has a bank of four 16 plate coolers with 10" centers. The unit is a cooler insert for tank #010808A.
Important Information!
The transmission plate oil coolers that Taalman supply are intended for use in systems that operate at 80 PSI to 125 PSI typical operating pressure.
The coolers are leak tested to 300 PSI and are statically burst tested to 1000 PSI.
Please ensure that the intended use of the cooler meets the above requirements. Taalman will NOT be responsible for any damage caused by failure of a cooler that is exposed to anything outside of the above parameters.
Learn More -
Oshkosh side frame
This side frame has four 5/16" NC threaded nuts along the edge, three 5/16" threaded nuts along the opposite edge, three 5/16" NC threaded nuts along the back, and an overhang with clearance holes.
Learn More -
Gillig Bus top tank
This tank has a 2" diameter hose connection, and two 3/8" NPT flanges on top. Learn More -
Bus washer bar
Dimensions: 17" x 1" x 1/4" thick - 11 bolt holes
This washer bar goes with oil cooler tank #010808A and matching core assembly #091609B.
Learn More -
Bus washer bar
Dimensions: 14 1/8" x 1" x 1/4" thick - 8 bolt holes
This washer bar goes with cooler tank #010808A and core assembly #091609B.
Learn More -
People Mover Bus bracket
This bracket has five holes to allow solder flow onto the tank, two holes on each end to tie into the side frames, and two key holes for bolts to slide into.
Note: used in conjunction with tank #080609B.
Learn More