Search results for '32 BH'
-
GMC bottom tank
This tank has a 1 1/4" diameter hose connection on the passenger side coming straight out, a 1" diameter hose connection on driver side on a 90o angle facing towards the center of the tank, two 1/4' NPT flanges, a baffle in the center of the tank, and two mounting nuts with 1/2" NC threads @ 8" centers. Learn More -
GMC bottom tank
This one-pass low flow tank has a 1 1/4" diameter hose connection coming straight out from passenger side facing the engine, a 1/4" NPT fitting next to the pipe, and a mounting bracket with two 1/2" NC threaded nuts @ 8" centers. Learn More -
GMC top tank
This low flow top tank comes complete with checkvalve. There are twenty five 5/16" NC threaded holes in the built inbaffle, a 1" diameter hose connection straight downfrom the baffle on passenger side, two 1/2" NPT andone 1/8" NPT flange facing the engine, a bolt-on typeflange on top of the tank to access the check valve. The top frontcorners of the tank are cut lower and there are two rounded cut-outs across topof tank, and a 1 1/4" diameter hole for filler neck ontop passenger side corner. Learn More -
Bus Top Frame
This frame has eight 3/8" NC threaded holes along each edge of the frame.
Note: matches tank #7433, #753, and #754.
Learn More -
Bus Btm Frame
This Bus frame has a length of 32 1/4", with eight 3/8" NC threaded holes along the edge of the frame, and four 1/2" NC threaded holes along the back of the frame.
Note: the header bolt pattern matches #7433, #753, #754 tanks.
Learn More -
Bus cross flow tank
This tank has a 2 3/4" diameter hose connection 6" from the edge of the tank to the center of the hose connection, and a cutout for a CAC. The grill side of the tank slopes inward.
Learn More -
Peterbilt bottom tank
This is a blank low flow tank with a 1/4" NPT flangefor a drain cock. Learn More -
Peterbilt bottom tank
This low-flow tank has one 1 1/4" diameter hose connectionon a 90o angle facing up and out to passengerside on approximately 45o angle. One 1/4"NPT flange for a drain fitting on the deep section of the tank. Learn More -
Peterbilt top tank
This tank is the same as tank #709,except that there is a baffle welded inside the header 18 1/4" from the drivers side of the tank.
Learn More -
Peterbilt top tank
This low flow tank comes complete with a check valve. The top partof the tank is 7 1/4" in from the edge of header on each side. There are two 1" diameter hose connections, a 3/8" diameter hoseconnection, a 1/4" NPT flange, three 5/16" NCthreaded holes in the tank (one on top and two on the front), and a 1 1/4" hole on top for a filler neck. Learn More