Search results for 'radiator'
-
Complete Radiator Set
TopTank
This tank has a 1" diameter hose connection, and a 1 3/8" hole for a filler neck.
Bottom Tank
This tank has a 1" diameter hose connection, a 1/2" NPT coupling for a drain, two 3/8" NC threaded mounting studs, and a 1/4" NPT flange on the grill side.
Side Frames
These frames are 20 1/2" long with two 1/4" NC threaded holes.
For this set, samples must be provided by the customer.
Learn More -
Mitsubishi solder-on tank set
Top Tank
This tank has a 1 7/8" diameter hoseconnection, a threaded mounting block on each end for attaching sideframes, and a 5/16" threaded stud for mounting the radiator.
Bottom Tank
Thistank has a 1 7/8" diameter hose connection, a threaded mounting blockon each end of the tank for attaching side frames, a 1/4" NPT flangefor a drain cock, and two 5/16" threaded studs @ 11 7/8" centers formounting the radiator. Learn More -
Ottawa Shunt Truck shroud
This shroud has overalldimensions of 26" x 24 1/2" x 4" deep. There is a 23 3/4" diameterhole for the fan, four 5/16" threaded mounting nuts, six slotted holesfor mounting the shroud to the radiator, and two large access slots toaccommodate a hose. Learn More -
Cat tank set
Top Tank
This tank has a 2" diameter hose connection, a mounting block on eachend with two 5/16" NC threaded holes, and a hole in the top center ofthe tank for a filler neck.
Bottom Tank
This tank has a 2" diameter hose connection, a mounting block on each end with two 5/16" threaded holes, a locating pin to position the radiator into the frame, and a 1/4" NPT flange for a drain.
Learn More -
Center Bar for four core radiator
This center bar is 1" thick by 1 1/4" wide headers. The original radiator template was 43 1/4" x 8 5/8" with 52 bolt holes.
Learn More -
Generator solder-on tank set
Inlet / Outlet Tank
This tank has a pair of 1 1/4" diameter hose connections (one at each end).
End Tank
This tank has a 3/8" NPT flange in the center of the tank, and a pair of brackets on the ends for mounting.
Note: originally Modine built radiator. Learn More -
-
New Flyer Bus washer bar
Long washer bar that belongs to tank #7435. Eight per radiator.
20 3/16" long by 3/4" wide. 1/4" thick.
Learn More -
Bolt-on bottom tank
This tank is essentially a #512 with modifications for a low flow application (based on the #707LF / #718LF radiator design).
Learn More -
International solder-on set
Top Tank
This tank has a 2 1/2" diameter hose connection facing towards the engine, and a 1/4" NPT flange for an expansion barb.
Bottom Tank
This tank has a 2 1/2" diameter hose connection facing downward from the radiator, and a 1/4" NPT fitting for a drain cock.
Note: This tank kit can be ordered in brass - #9214
Learn More
Recently Viewed Products
My Quote
You have no items in your quote.