Search results for 'case'
-
Case solder-on tank set
Top Tank
This tank has a 1 1/2" diameter hose connection 1 3/4" from the edge of the tank to the center of the hose connection, and a 7/8" hole on the top for an import filler neck (part#1005).
Bottom Tank
This tank has a 1 1/2" diameter hose connection in the center of the tank, and a 1/4" NPT flange for a drain fitting on the grill side of the tank.
Learn More
-
John Deere tank set
Top Tank
This tank has a 2" diameter hose connection, and 1 1/4" diameter hole for a filler neck.
Bottom Tank
This tank has a 2" diameter hose connection, and a 1/4" NPT flange for a drain.
Learn More
-
John Deere solder-on tank set
The top tank has a 1 1/2" diameter hose connection and a hole for a filler neck, and the bottom tank has a 1 7/8" diameter hose connection, and a 1/4" NPT flange for a drain fitting on the grill side.
Learn More
-
Case Loader solder-on tank
This tank has a 2 1/4" diameter hose connection 7 1/4" in from the edge of the tank to the center of the hose connection.
Learn More
-
John Deere solder-on tank set
These tanks have 2" diameter hose connections. The top tank has a hole for a filler neck, and the bottom tank has three 1/2" NC threaded mounting studs and a 1/4" NPT flange for a drain fitting.
Learn More
-
Case Loader solder-on set
These tanks have a 2 1/2" diameter hose connection. The top tank has a hole for a filler neck and a deflection baffle under the fill hole. The bottom tank has a 1216PC oil cooler and a 1/4" NPT flange for a drain fitting.
Learn More
-
John Deere mounting bracketThis bracket is designed tofit over the bottom tank of brass kit #9700 (tank #3047), or the bottomtank of the corresponding steel kit #080808A.
There are six 3/8"NC threaded mounting holes, eight 3/8" clearance holes, a cut-out forthe hose connection, and a cut-out to access the drain cock.
Learn More
-
Case solder-on tank set
These tanks have 2" diameter hose connections. The top tank has a hole for a filler neck and two 5/16" NC threaded holes on each end to attach side frames, and the bottom tank has a 1/4" NPT coupling for a drain fitting and two mounting pins with 1/4" NC threaded holes in the center.
Learn More
-
John Deere tank set
Top Tank
This tank has a 1 1/2" diameter hose connection that comes out on an angle, four 5/16" NC threaded nuts to attach side frames, a 1 3/8" diameter hole for a filler neck, a 1 3/8" diameter stand pipe for a filler neck (original tank had a screw-cap filler), three 1/4" NPT flanges for a sensor and expansion fittings, and a small surge tank built into the top.
Bottom Tank
This tank has two holes @ 9 1/2" centers for an oil cooler, a 5/8" bypass hose, a 1 3/4" diameter hose connection, a mounting bar running along the center of the tank, and four 5/16" threaded nuts to attach side frames.
Learn More
-
Case solder-on bottom tank
This tank has a 2 1/2" diameter hose connection 2 1/2" from the edge of the tank to the center of the hose connection, and a mounting bracket at each end.
Note: this tank matches with top tank #062207A. Learn More