Search results for 'peterbilt'
-
Peterbilt bottom tankThis is a blank low flow tank with a 1/4" NPT flangefor a drain cock.
Learn More
-
Peterbilt bottom tankThis low-flow tank has one 1 1/4" diameter hose connectionon a 90
o angle facing up and out to passengerside on approximately 45
o angle. One 1/4"NPT flange for a drain fitting on the deep section of the tank.
Learn More
-
Peterbilt top tankThis tank is the same as tank #709,except that there is a baffle welded inside the header 18 1/4" from the drivers side of the tank.
Learn More
-
Peterbilt top tankThis low flow tank comes complete with a check valve. The top partof the tank is 7 1/4" in from the edge of header on each side. There are two 1" diameter hose connections, a 3/8" diameter hoseconnection, a 1/4" NPT flange, three 5/16" NCthreaded holes in the tank (one on top and two on the front), and a 1 1/4" hole on top for a filler neck.
Learn More
-
Peterbilt top tankThis low flow tank comes complete with a check valve. There is a 1 1/4" diameter hose connection on the drivers side bentslightly up and towards the center, two 1" diameter hoseconnections on 90
o angle, a 3/8" diameter hoseconnection on the top drivers side, a 1/4" NPT flange, and three 5/16" NC threaded holes in the tank (oneon top and two on the front).
A baffle splits the tank left toright.
Learn More
-
Peterbilt / Kenworth solder-on tank set
Top Tank
This tank has a 2 1/2" diameter hose connection 11 1/2" from the end of the tank to the center of the hose connection, four mounting bosses to attach side frames, and a 1/4" NPT flange for an expansion fitting.
Bottom Tank
This tank has a 2 1/2" diameter hose connection 11 1/2" from the end of the tank to the center of the hose connection, and four mounting bosses to attach the side frames.
New 2011 Kenworth 440
Learn More
-
Peterbilt solder-on tank set
These tanks have a 2 1/2" diameter hose connection, four mounting bosses to attach side frames, and a 1/4" NPT flange for a drain/expansion fitting.
Virtually identical to #110409A, but with a different height of the upper hose connection. Learn More
-
Peterbilt solder-on tank set
These tanks are identical to each other. They have a 2 1/2" diameter hose connection on a 90
o angle, four mounting bosses to attach the side frames, and a 1/4" NPT flange for a drain/expansion fitting.
Learn More
-
Peterbilt / Kenworth solder-on tank setBoth of these tanks are identical. Each has a 2 1/2" diameter hose connection 13 7/8" from the edge of the tank to the center of the hose connection, two mounting bosses on each end to attach side frames, and a 1/4" NPT flange to accommodate a drain cock or expansion fitting.
This tank set is supplied with eight 5/16" x 4 1/2" bolts with nuts, a 1/4" NPT drain cock, and a 1/4" NPT 90o hose barb.
Learn More
-
Kenworth solder-on tank setThese tanks are identical. They have 2 1/2" diameter hose connections that angle towards the core, and a 1/4" NPT coupling for a drain/expansion fitting. Individual tank #4114.
Brass version #9502.
Learn More
