Search results for 'mack'
-
Volvo / GM / Mack solder-on tank set
Top Tank
This tank has a 2 1/2" diameter hose connection, a pair of mounting bosses at each end to attach side frames, four 1/4" NC threaded blocks on the top, four 1/4" NC threaded blocks on the grill side, and a 1/4" NPT flange for an expansion barb.
Bottom Tank
This tank has 2 1/2" diameter hose connection on right side of tank, the flange is for a drain cock, and there are holes @ 11 1/2" centers to accommodate an oil cooler (to be supplied and installed by the customer).
Learn More
-
Solder on Radiator
core 28.78" x 39.17" x 2", 3 row, RT Type, Top tank hose connection. 2" dia. and btm tank hose conn. is 2 1/2" dia.
Taalman top tank #2650T and btm tank #2650B
tanks can be sold separately
Learn More
-
Mack mini bolt on tanks and rails
HDR: 40 1/2" x 3 1/2" - 64BH, top hose connection is 2", 14 1/4" from end to center, btm is 2 1/2" 15" from end to center, pins are 2 1/2" center to center rails are 29" tall. complete with washer bars
These are limited qty and have been discontinued, our solder on version is Taalman #2650CK steel
Learn More
-
Mack bottom tankThis tank has a 3" diameter hose connection, two keyhole brackets @ 15 3/4" centers, and a 3/8" NPT flange.
Learn More
-
Mack Vision blank brass header
Header size: 29 1/8" x 2 1/2"
Learn More
-
Mack blank brass header
Header size: 40 1/4" x 2 3/4"
Learn More
-
Mack Advance bottom tankThis tank has two mounting plates with a 5/8" NC threaded hole in the center, a 1" diameter hose connection that runs along the front of the tank, a 1 1/4" diameter hose connection, and two 1/4" NPT drain flanges. A baffle divides the tank across the width.
Learn More
-
Mack Advance top tankThis top tank has an angle bracket on the top of the tank with 6 holes, a 1" hose connection in the center of the tank, two 1/4" NPT fittings, a 1/2" NPT fitting on the back for a sight glass, a hole for filler neck on the top of the tank, a 1" NPT access for a check valve, and a 3/4" NPT fitting for a fill bypass.
Learn More
-
Volvo / Mack plate oil cooler
This oil cooler has seven plates, and the fittings are spaced 10" apart center to center. Cooler comes supplied with large faced fasteners and rubber O rings that fit into a built-in recess.
Important Information!
The transmission plate oil coolers that Taalman supply are intended for use in systems that operate at 80 PSI to 125 PSI typical operating pressure.
The coolers are leak tested to 300 PSI and are statically burst tested to 1000 PSI.
Please ensure that the intended use of the cooler meets the above requirements. Taalman will NOT be responsible for any damage caused by failure of a cooler that is exposed to anything outside of the above parameters.
Learn More
-
Mack side frameBoth flanges have 10 holes, 2 tapped 3/8" NC and 8drilled clearance for 3/8" bolts. Two angle brackets onside, with a 5/16" NC threaded hole in each. Variousother holes for shroud and brackets, etc.
Note: frames are not interchangeable. Order left fordrivers side or right for passengers side or pairs. Learn More