Side Frame
-
GMC frames
One end is 7 1/8" wide with four 3/8" diameter holeson each side. The other end is 6 1/2" wide, also withfour 3/8" diameter holes on each side. (4 holes oneach side to accommodate more than one model) Two1/2" NC mounting studs at 37 7/8" centers. One sideof the frame has a bracket with six 5/16" NCthreaded holes. The other side of the frame also hassix 5/16" NC threaded holes plus a 5/16" NCthreaded stud in the center. Learn More -
Orion 5 side frame
This frame has eight 3/8" NC threadedholes and two 1/4" threaded holes along each edge, and a mountingbracket on the back of the frame. Learn More -
New Flyer Bus side frame
This frame has twelve 3/8" NC threaded holes and eight 5/16" NC threaded holes on the back of the rail, and seven 5/16" NC threaded holes along each edge. Flanges have eight holes each (four of them threaded 5 /16" NC).
Learn More -
Peterbilt side frame
Flanges each have 12 holes, 2 tapped 5/16" NC and 10 drilled clearance for 5/16" bolts. Engine side of rail is flush with flanges with seven 1/4" NC threaded holes. Six 1/4" NC threaded holes on side. Two brackets on rail - one for CAC and one for mounting pin.
Note: frames are not interchangeable. Left side shown here.
Learn More -
Peterbilt side frame
Top and bottom flanges each have 12 holes, ten drilledclearance for 5/16" bolts and two tapped 5/16" NC.One bracket on side of channel near top with twoholes drilled clearance for 1/2" bolts. Angle bracketson each side of channel with 1/4" NC threaded holes.
Note: frames are not interchangeable. Order left or right accordingly.
Learn More -
Peterbilt side frame
Flanges on both ends have 13 holes, all clearance for5/16" bolts. One angle on each side, full length withfive 1/4" NC threaded nuts on each.
Note: frames are interchangeable. Learn More -
Peterbilt side frame
Top flange has 13 bolt holes drilled clearance for5/16" bolts. Bottom flange has 9 bolt holes drilled for5/16" bolts. One angle mount on grille side. Variousother holes for brackets, etc.NOTE: Frames are not interchangeable. Order left fordrivers side or right for passengers side or pairs Learn More -
Peterbilt side frame
Same as model #720 except shorter.
Note: frames are not interchangeable. Order left fordrivers side or right for passengers side of pairs Learn More -
Peterbilt side frame
Top flange has 11 bolt holes drilled clearance for5/16" bolts. Bottom flange has 8 bolt holes drilledclearance for 5/16" bolts. One angle mount on grilleside. Various other holes for brackets, etc.
Note: frames are not interchangeable. Order left fordrivers side or right for passengers side or pairs. Learn More -
Mack side frame
Both flanges have 10 holes, 2 tapped 3/8" NC and 8drilled clearance for 3/8" bolts. Two angle brackets onside, with a 5/16" NC threaded hole in each. Variousother holes for shroud and brackets, etc.
Note: frames are not interchangeable. Order left fordrivers side or right for passengers side or pairs. Learn More