Bottom Tank
-
Oshkosh bolt-on bottom tank
This tank has a 2" diameter hose connection, and a #1018PC plate oil cooler.
Learn More -
1946 Welland Tractor bottom tank
This tank has a 2 7/8" diameter hose connection, and a 1/4" NPT flange for a drain fitting.
Learn More -
Gillig Bus btm tank
This tank has a 3" diameter hoseconnection in the front center of the tank, and a 1/4" NPT flange onthe top for an expansion fitting.
Note: pairs with bottom tank #073109G Learn More -
Locomotive Bottom Tank
This tank has a 2" NPT coupling, and two mounting blocks with a hole for the bolts.
SAMPLE REQUIRED
Sample Required Learn More -
Ottawa Shunt Truck bottom tank
This tank has a 2"diameter hose connection, a 1" diameter bypass connection, a 1/2" NPTflange, a 1/4" NPT flange for a drain cock on the grill side of thetank, a mounting bracket with three holes for bolting into the unit andone larger hole for the isolation rubber, an extension bracket with thesame bolt pattern as the mounting bracket, and a seven plate oil coolerwith 18" centers (718PC). Learn More -
Generator bottom tank
This bottom tank has a 3 1/2" hose connection in the center of the tank, facing downward, and offset to the one side. Learn More -
Oshkosh bolt-on bottom tank
This tank has a bolt-on style flange, two 5/8" diameter mounting holes, and two mounting blocks @ 8" centers.
Learn More -
Gen Set bolt-on bottom tank
This tank has a 2 1/2" diameter hose connection, a 1" diameter bypass hose on the grill side of the tank, a bracket on the back, and a 3/4" NPT coupling for drainage.
Learn More -
Bus Bottom Tank
This tank has a 2 3/4" diameter hose connection that comes out the bottom and angles @ 90o, a 3/8" NPT flange for a drain, and two 5/16" NC threaded holes on each end of the tank.
Learn More -
Ottawa Shunt Truck bolt-on tank
This tank has two bolt-on styleflanges to accommodate 2 1/4" diameter hose connections. The flangesare 2 1/2" in from the edge of the tank to the center of the flange,and they angle upward slightly towards the engine. There is a 12 plate16" center oil cooler with 3/4" NPT fittings, positioned between theflanges, a 1/4" NPT flange near the bottom of the tank for a draincock, and a large mounting bracket at the bottom center of the tank. Learn More