Bolt On Tanks
-
Hobart Welder top tank
This tank has a 1 3/4" diameter hose connection 6 3/4" from the edge of the tank to the center of the hose connection, a 1" diameter bypass hose 11 3/8" from the edge of the tank, a 1/4" NPT flange to accommodate a sensor, and a 1 3/4" diameter hole in the top center of the tank to accommodate a filler neck.
Learn More -
Bus bolt-on top tank
This tank has a 2" diameter hose connection on passenger side facing the engine, a 1" diameter hose connection near the center facing the engine, a 1 1/4" diameter hose connection on the bottom on a 45o angle facing the driver-side corner, two 1/4" NPT flanges on the engine side, a 1/2" NPT flange on the engine side, and a 1/4" NPT flange on the bottom.
There is a de-airation tube welded in the PTO cutout.
Washer Bars (sold seperately)
LONG - 26 3/4" x 1" x 1/4" - 15 BH @ 3/8"
SHORT - 3 7/8" x 1" x 3/8" - 3 threaded holes @ 5/16" NC
Learn More -
Bolt-on tank set
This top tank has an overall height of 5". A 2 1/2" NPT nipple hose connection is on the left side, with a 1/2" NPT coupling for sensor nearby, and a 1/2" NPT sight glass flange. The 2 1/2" studs at each end are 3" long, and the top center of the tank has a truck-sized fill neck hole. Learn More -
Euclid bottom tank
This tank has a 2" diameter hose connection that angles downward, a 3/4" diameter bypass hose connection, a 1/4" NPT flange for a drain fitting, and a pair of 3/4" mounting studs @ 35" centers.
Learn More -
Cummins 8.3 complete rad set
Top Tank
This tank has a 2 1/4" diameter hose connection, a 3/4" diameter bypass hose, two 1/4" NPT flanges, two 1/2" diameter flanges for sight glasses, and a 2" diameter pipe on the top for a filler neck.
Bottom Tank
This tank has a 2" diameter hose connection, and three 1/4" diameter flanges.
Side Frames
These frames are 44 7/8" long and 9" wide. There are slotted mounting holes top and bottom, and two bolt holes on the bottom.
Note: this set comes supplied with four long and four short washer bars.
Learn More -
Gillig Bus top tank
This tank has a 2" diameter hose connection, and two 3/8" NPT flanges on top. Learn More -
Thomas Bus bolt-on bottom tank This tank has a 2" diameter hose connection, a 1/4" NPT flange for a drain fitting on the grill side, and a 1018PC plate oil cooler. Learn More -
Fire Truck Bottom Tank
This tank has a 3" diameter hose connection, two 5/8" threaded studs @ 8" centers, and a 1/4" NPT flange on the grill side for a drain cock.
Learn More -
This bottom tank has a 2" diameter hose connection, a 1/4" NPT flange for a drain, two mounting pads @ 18" centers, and a 12 plate oil cooler with 16" centers (in place of the tube bundle type cooler).
Learn More -
John Deere tank
This tank has a 2 3/4" diameter hose connection 6 3/4" infrom the edge of the tank to the center of the hose connection, a pairof mounting brackets, and a 1/4" NPT flange on the top of the tank nearthe hose connection. Learn More