Bolt On Tanks
-
Bus Bottom Tank
This tank has a bolt-on type flange with two clearance holes for 3/8" bolts,and two mounting blocks with two 7/16" NC threadedholes in each, and two 1/4" NC threaded nuts on the headerfacing the engine.
Note: pairs with tank #744 Learn More -
Bus top tank
This tank has a bolt-on type filler with two 3/8" NC threads, two 3/8" NC threaded holes next to the filler opening, two 7/16" NC threaded holes at the end of the tank, three5/16" NC threads along one side of the tank, two blocks with two 1/4" NC threaded holes on the opposite side ofthe tank.
Note: pairs with tank #745. Learn More -
Peterbilt bottom tank
Two bolt-on type flanges with two 7/16" NC threadsin each. One bolt-on type flange with two 5/16" NCthreads. Two mounting holes with 5/8" NC threadsat 16" centers. Tank dips in the middle to accommodate a PTO. Learn More -
Peterbilt bottom tank
This tank has two bolt-on type flanges with two 7/16" NC threadsin each, a bolt-on type flange on the opposite side withtwo 5/16" NC threads, and two mounting holes with5/8" NC threads @ 16" centers. Learn More -
International cross flow tank
This tank has a 2 1/2" diameter hose connection that bends at 90o, and a 1/2" NPT flange on end of the tank. Learn More -
International cross flow tank
This tank has a 2 1/2" diameter hose connection straight out tothe engine 10 3/8" in from end to center, and one 1/4" NPTcoupling welded in end of tank on approximately a 45o angle. Learn More -
International cross flow tank
This tank has a 2 1/2" diameter hose connection that bends @ 90o and angles slightly upwards, and a 1/4" NPT flange on the end. Learn More -
Case Tractor bolt-on tank
This tank has a 2 1/2" diameter hose connection, an 818PC oil cooler to replace the original tube-bundle cooler, a 1/4" NPT flange for a drain fitting, and a mounting bracket on each end.
Learn More -
John Deere tank
This tank has a 2 3/4" diameter hose connection 6 3/4" infrom the edge of the tank to the center of the hose connection, a pairof mounting brackets, and a 1/4" NPT flange on the top of the tank nearthe hose connection. Learn More -
This bottom tank has a 2" diameter hose connection, a 1/4" NPT flange for a drain, two mounting pads @ 18" centers, and a 12 plate oil cooler with 16" centers (in place of the tube bundle type cooler).
Learn More