Side Frame
-
International side frame
This frame has seven 3/8" NC threaded holes on the back, six 1/4" NC threaded holes along each edge, and a mounting bracket on the back.
Learn More -
Top and bottom flanges have 11 holes each, all drilledto clear 5/16" bolts. One bracket on back of side framechannel. Various other holes for brackets, shrouds,etc.
Note: frames are interchangeable. Learn More -
International side frame
Small end has 8 holes, 4 tapped 5/16" and 4 drilledclearance 5/16" bolts. Large end has 9 holes, 6 taped5/16" and 3 drilled clearance for 5/16" bolts. Twomounting angles on back of frame, one has 5 holeswith 5/16" N.C. threads, the other has 4 holes drilledclearance for 3/8" bolts. Various other holes forbrackets, etc.NOTE: Frames are not interchangeable. Order left fordrivers side or right for passengers side or pairs. Learn More -
International side frame
Top and bottom flanges have 6 holes each, all drilledclearance for 5/16" bolts. Top of frame has offsetbracket with 5 header holes drilled clearance for 5/16"bolts. Sides of frame have five 5/16" N.C. threadedstuds, three facing engine and two facing grille. Oneangle bracket on back with 1 1/16" diameter hole.Two sleeves welded on gussets to accommodate crossbars. Various other holes for brackets, mounting, etc.
Note: frames are not interchangeable. Order left fordrivers side or right for passengers side or pairs. (right shown here)
Learn More -
International side frame
Top flange is L shaped with 10 holes drilledclearance for 5/16" bolts. Top flange also has 1/8"step on overhang. Bottom flange has 11 holes drilledclearance for 5/16" bolts. One bracket on side offrame with a 1-1/16" diameter hole. Various otherholes for brackets, shroud, etc.NOTE: Frames are not interchangeable. Order left fordrivers side or right for passengers side or pairs. Learn More -
International frame
Cross flow bottom frame. Frame is similar to #654B except the header is offset. Learn More -
International Frame
Cross flow top frame. Frame is similar to #654T except the header is offset. Learn More -
International cross flow bottom frame
Both flanges step down1/4" at gussets. Both flanges have 10 holes, 4 tapped5/16" NC and 6 drilled clearance for 5/16" bolts.Channel is cut-out in center to accommodate bolts onmounting bracket. Frame has a total of 31 holes alltapped 5/16" NC for brackets and shroud, etc. formounting bracket. Learn More -
International side frame
Cross flow top frame. Both flanges step down 1/4" atgussets. Both flanges have 10 holes, 4 tapped 5/16"N.C. and 6 drilled clearance for 5/16" bolts. Framehas a total of 25 holes for brackets and shroud, etc., 21holes tapped 5/16" N.C. and 4 holes are drilledclearance for 3/8". Learn More -
International side frame
This cross flow top frame has ten holes in each flange - two threaded @ 5/16" NC. There are seven 5/16" NC threaded studs and two angle brackets with 3/8" holes on the back of the frame, four 5/16" NC threaded studs on grill side, and four 5/16" NC threaded holes on shroud side.
Note: this frame pairs with frame #6551, as well as tanks #643C, #643-2LF, and #643-3LF.
Learn More